Setting Parameters - ABB RET670 Applications Manual

1MRK504116-UUS C
3.14.1.3
Table 201: SMPPTRC (94) Group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
Program 3 phase
1p/3p
1p/2p/3p
tTripMin 0.000 - 60.000
tWaitForPHS 0.020 - 0.500
Table 202: SMPPTRC (94) Group settings (advanced)
Name Values (Range)
TripLockout Disabled
Enabled
AutoLock Disabled
Enabled
3.14.2
3.14.2.1
3.14.2.2
Application manual

Setting parameters

Unit Step
- -
- -
s 0.001
s 0.001
Unit Step
- -
- -
Trip matrix logic TMAGGIO
Function description
Trip matrix logic
Application
Trip matrix logic TMAGGIO function is used to route trip signals and other logical
output signals to different output contacts on the IED.
TMAGGIO output signals and the physical outputs allows the user to adapt the signals
to the physical tripping outputs according to the specific application needs.
Setting guidelines
Operation: Operation of function Enabled/Disabled.
Default Description
Enabled Disable/Enable Operation
1p/3p Three pole; single or three pole; single, two or
three pole trip
0.150 Minimum duration of trip output signal
0.050 Secures 3-pole trip when phase selection
failed
Default Description
Disabled If TripLockout is set to On, it will activate
output (CLLKOUT) and trip latch. If set to Off
it will activate only CLLKOUT
Disabled If AutoLock is set to On i will activate lockout
from input (SETLKOUT) and trip, If set to Off
it will activate only from SETLKOUT
IEC 61850 IEC 60617
identification identification
TMAGGIO -
Section 3
IED application
ANSI/IEEE C37.2
device number
-
741