Setting Parameters - ABB RET670 Applications Manual

1MRK504116-UUS C
3.12.5.3
Table 173: SLGGIO Non group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
NrPos 2 - 32
OutType Pulsed
Steady
tPulse 0.000 - 60.000
tDelay 0.000 - 60000.000
StopAtExtremes Disabled
Enabled
3.12.6
3.12.6.1
Application manual
tPulse: In case of a pulsed output, it gives the length of the pulse (in seconds).
tDelay: The delay between the UP or DOWN activation signal positive front and the
output activation.
StopAtExtremes: Sets the behavior of the switch at the end positions – if set to
Disabled, when pressing UP while on first position, the switch will jump to the last
position; when pressing DOWN at the last position, the switch will jump to the first
position; when set to Enabled, no jump will be allowed.

Setting parameters

Unit Step
- -
- 1
- -
s 0.001
s 0.010
- -
Selector mini switch VSGGIO
Function description
Selector mini switch
Application
Selector mini switch (VSGGIO) function is a multipurpose function used in the
configuration tool in PCM600 for a variety of applications, as a general purpose
switch. VSGGIO can be used for both acquiring an external switch position (through
the IPOS1 and the IPOS2 inputs) and represent it through the single line diagram
symbols (or use it in the configuration through the outputs POS1 and POS2) as well as,
a command function (controlled by the PSTO input), giving switching commands
through the CMDPOS12 and CMDPOS21 outputs.
The output POSITION is an integer output, showing the actual position as an integer
number 0 – 3.
Default Description
Disabled Operation Enable/Disable
32 Number of positions in the switch
Steady Output type, steady or pulse
0.200 Operate pulse duration, in [s]
0.000 Time delay on the output, in [s]
Disabled Stop when min or max position is reached
IEC 61850 IEC 60617
identification identification
VSGGIO -
Section 3
IED application
ANSI/IEEE C37.2
device number
-
707