Replacement Procedure - Ricoh D009 Service Manual

Electrical Components

Replacement Procedure

1. Controller unit ( Section 3.16.1 "Controller Unit")
2. HDD unit (if it has been installed.) ( Section 3.16.2 "HDD Unit (Standard for
D011/D013)")
3. FCU cover [A] (
4. Controller left bracket [B] (
5. Controller board assembly [C] (
6. Interface rails [D] (hooks each)
7. NVRAMs [E]
8. DIMM-RAM (If it is installed.)
9. Controller board [F]
When installing the new controller board
1. Remove the NVRAMs from the old controller board.
2. Install them on the new controller board after you replace the controller board.
D009/D011/D012/D013
x 3)
x 5)
x 4, connector caps)
3-80 SM