Lamp Stabilizer - Ricoh D009 Service Manual

Scanner -1
2. Scanner right cover [A] (
3. SBU cover bracket [B] (
4. Ground plate [C] (
5. Sensor board unit [D] (
When reassembling
Adjust the following SP modes after you replace the sensor board unit:
SP4–008 (Sub Scan Mag): ( Section 3.17.3 "Scanning").
SP4–010 (Sub Mag Reg.): ( Section 3.17.3 "Scanning")
SP4–011 (Main Scan Reg): ( Section 3.17.3 "Scanning") "
SP4–688 (DF: Density Adjustment): Use this to adjust the density level if the ID of
outputs made in the DF and Platen mode is different.

3.4.6 LAMP STABILIZER

1. Rear cover ( Section 3.3.3 "Rear Cover")
2. Scanner rear frame ( Section 3.4.4 "Scanner Motor")
D009/D011/D012/D013
x 2)
x 4)
x 4)
x 4, x 3, x 1)
3-14 SM