Mixed Original Size Mode - Ricoh D009 Service Manual

Symbols
O: Yes (Default), : Yes (Can select this with SP mode), ON: Paper present, LT: North
America, A/B: Europe, Asia
For "O/ " mark, which has superscripted number, it is possible to change the
original detection size with SP6-016. For example, instead of LT (O
can be set up to detect 10" x 8" (
The F size can be selected with SP5-126. The default is 8.5" x 13"
The machine cannot detect more than one size of original in the same job.

2.2.2 MIXED ORIGINAL SIZE MODE

This section explains what happens when the user selects mixed original size mode.
Because this ARDF is a sheet-through document feeder, the method for original document
width detection is the same as when the originals are the same size, but the document
length detection method is different. Therefore, the scanning speed is slightly slower.
Document length detection
From when the skew correction sensor switches on until it switches off, the CPU counts the
transport motor pulses. The number of pulses determines the length of the original.
Feed-in cycle
When the original size for the copy modes listed below cannot be determined, the image
cannot be correctly scaled (reduced or enlarged) or processed until the original's length
has been accurately detected. The length must be determined before the image is
scanned.
Auto Reduce/Enlarge
Centering
Erase Center/Border
Booklet
Image Repeat
The originals follow this path:
1. Length detection
SM
3
).
Scanning glass Inverter table
25
Basic Operation
3
), the machine
B802