Installation Procedure - Ricoh D009 Service Manual

DataOverwriteSecurity Unit Type I (D362)
You must check the box seals to make sure that they were not removed after the
items were sealed in the box at the factory before you do the installation.
1. Check the box seals [1] on each corner of the box.
Make sure that a tape is attached to each corner.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
install the components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the
box.
3. You can see the "VOID" marks [2] when you remove each seal. In this condition, they
cannot be attached to the box again.

1.20.3 INSTALLATION PROCEDURE

Unplug the main machine power cord before you do the following procedure.
You must install the DataOverwriteSecurity unit in SD Card slot 1. However, the
Postscript option and others are also installed in SD Card slot 1. You must do the
"SD Card Appli Move" procedure first if you want to install the
DataOverwriteSecurity unit.
1. Turn off the main power switch if the machine is turned on.
2. Disconnect the network cable if it is connected.
3. Remove the slot cover [1] for SD cards (
D009/D011/D012/D013
x 1).
1-72 SM