Id Sensor - Ricoh D009 Service Manual

4. Remove drum cleaning blade 1 [A] (
Re-installation
Put toner on the edge of cleaning blade 1 and the mylar at the back side of cleaning blade 1
before re-installing this blade.
After re-assembly, make sure that the front spring of the movable cleaning blade is
re-attached to the

3.7.7 ID SENSOR

1. Left cover ( Section 3.3.2 "Left Cover")
2. Paper exit cover ( Section 3.3.6 "Paper Exit Cover")
3. Inner tray ( Section 3.3.7 "Inner Tray")
4. Exhaust duct ( Section 3.15.10 "Toner Supply Motor")
5. PCDU ( Section 3.7.1 "PCDU (Photoconductor and Development Unit)")
6. Fusing unit ( Section 3.11.1 "Fusing Unit")
7. ID sensor bracket [A] (
8. ID sensor [B] ( x 1)
Do SP3-001-002 to initialize the ID sensor after replacing.
SM
x 2)
, position. ( Section 3.7.2 "Drum")
x 2, x 1)
3-35
PCDU
D009/D011/D012/D013