Controller Board - Ricoh D009 Service Manual

After installing the new HDD unit
1. Do SP5832-001 to format the hard disk.
2. Do SP5853-001 to copy the preset stamp data from the firmware to the hard disk.
3. Do SP5846-052 to copy back the address book to the hard disk from the SD card to
which you have already copied the address book data if possible.
4. Turn the main power switch off/on.
Disposal of HDD Units
Never remove an HDD unit from the work site without the consent of the client.
If the customer has any concerns about the security of any information on the HDD, the
HDD must remain with the customer for disposal or safe keeping.
The HDD may contain proprietary or classified (Confidential, Secret) information.
Specifically, the HDD contains document server documents and data stored in
temporary files created automatically during copy job sorting and jam recovery. Such
data is stored on the HDD in a special format so it cannot normally be read but can be
recovered with illegal methods.
Reinstallation
Explain to the customer that the following information stored on the HDD is lost when
the HDD is replaced: document server documents, fixed stamps, document server
address book
The address book and document server documents (if needed) must be input again.
If the customer is using the Data Overwrite Security or the Data Encryption feature,
these applications must be installed again. For more, see "Installation".
If the customer is using the HDD Encryption Unit, the encryption key must be restored
after replacing the HDD unit. For details, see the installation procedure for the HDD
Encryption Unit.

3.16.3 CONTROLLER BOARD

The battery on the control board can explode if replaced incorrectly.
Dispose of the old battery in accordance with the instructions.
Before replacing the controller board in the model without HDD
When you replace the controller board in a model without a HDD, address book data can be
copied from an old controller board to a new controller board using an SD card.
Copy the address book data to an SD card from the flash ROM on the controller board with
SP5846-051 if possible.
SM 3-79
Electrical Components
D009/D011/D012/D013