Ricoh D009 Service Manual page 829

Connecting Procedure for Op Panel
3. Remove the two screws on the
operation panel drive board [4].
4. Attach the operation panel interface board [3] as shown (
removed in step 3 in this procedure).
5. Connect the harness [2] to CN700 on the operation panel drive board and
install the core [5] (RFC-8).
6. Put the operation panel I/F cable [6] through the scanner front cover [7].
7. Connect the three connectors [8] of the operation panel I/F cable to
operation panel interface board.
SM 21
x 2; these are
B838R932.PNG
B838