Ricoh D009 Service Manual page 409

LDAP Search Timeout
010
Sets the length of the time-out for the search of the LDAP server.
[1 to 255 / 60 /1 step]
Addr Book Migration (USB -> HDD)
This SP moves the address book data from the SD card or flash ROM on the
controller board to the HDD. You must cycle the machine off and on after
executing this SP.
1. Turn the machine off.
2. Install the HDD.
3. Turn the machine on.
4. Do SP5846 040.
040
5. Turn the machine off/on.
Executing this SP overwrites any address book data already on the
HDD with the data from the flash ROM on the controller board.
We recommend that you back up all directory information to an SD
card with SP5846-051 before you execute this SP.
After the address book data is copied to HDD, all the address book
data is deleted from the flash ROM. If the operation fails, the data is
not erased from the flash ROM.
041 Fill Addr Acl Info.
This SP must be executed immediately after installation of an HDD unit in a
basic machine that previously had no HDD. The first time the machine is
powered on with the new HDD installed, the system automatically takes the
address book from the NVRAM and writes it onto the new HDD. However,
the new address book on the HDD can be accessed only by the system
administrator at this stage. Executing this SP by the service technician
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD
SM 5-123
SP5-xxx: Mode-4
D009/D011/D012/D013