Ricoh D009 Service Manual page 80

Punch Unit (B702)
5. Move the punch unit [5] along its rails into the finisher. Make sure that the pin engages
correctly at the front and rear.
6. Connect the cables [6] of the finisher to the connectors (CN601 and CN602) on the
punch unit board (
The cables [6] are coiled and attached to the PCB.
7. Attach the slide drive unit [7] to the finisher and connect it to the punch unit (
1). Push in the slide drive unit at
8. Make sure that the punch unit moves freely and is not blocked by the screws.
D009/D011/D012/D013
x 2, x 1).
when you attach the screw
1-46
x 2,
.
SM
x