Ricoh D009 Service Manual page 955

0: OFF, 1: ON (enable)
IP Fax T30 bit signal reverse
5
0: LSB first, 1: MSB first
IP Fax max bit rate setting
6
0: Not affected, 1: Affected
IP Fax received telephone number
confirmation
7
0: No confirmation, 1:
Confirmation
IP-Fax Switch 01
No. FUNCTION
Select IP FAX Delay Level
Bit3 Bit2 Bit1
0 0 0
0 0 0
0-3
0 0 1
0 0 1
4-7 IP Fax preamble wait time setting
SM
gatekeeper for IP-Fax.
Reverses the T30 bit signal.
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate affects
the value of the DIS/DCS.
When "0" is selected, fax data is received
without checking the telephone number.
When "1" is selected, fax data is received
only when confirming that the telephone
number from the sender matches the
registered telephone number in this
machine. If this confirmation fails, the line is
disconnected.
Raise the level by selecting a higher setting
if too many transmission errors are occurring
Bit0 Setting
on the network.
If TCP/UDP is enabled on the network, raise
0 Level 0
this setting on the T.30 machine. Increasing
1 Level 1
the delay time allows the recovery of more
lost packets.
0 Level 2
If only UDP is enabled, increase the number
1 Level 3
of redundant packets.
Level 1~2: 3 Redundant packets
Level 3: 4 Redundant packets
Selects the preamble wait time.
[00 to 0f]
There are 16 values in this 4-bit binary
109
Bit Switches
COMMENTS
D346