Ricoh D009 Service Manual page 914

Bit Switches
RTI/CSI display priority
2
0: RTI 1: CSI
File No. printing
3 0: Enabled
1: Disabled
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
4 yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
5-7 Not used
System Switch 1F [SP No. 1-101-032]
No FUNCTION
0 Not used
Report printout after an
original jam during SAF
storage or if the SAF memory
1
fills up
0: Enabled
1: Disabled
2 Not used
3 Received fax print start timing
D346
transmission.
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from
any sender that includes an RTI or CSI, and to
block messages from senders that do not include
an RTI or CSI, change this bit to "1", then enable
Authorized Reception.
Otherwise, keep this bit at "0 (default setting)".
Do not change the settings
COMMENTS
Do not change the settings.
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to "1" if the customer does not
want to have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after
68 SM