Ricoh D009 Service Manual page 906

Bit Switches
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION
Addition of image data from
confidential transmissions on
0
the transmission result report
0: OFF 1: ON
Inclusion of communications
on the Journal when no image
1
data was exchanged.
0: Disabled 1: Enabled
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on
3 the error report
0: OFF1: ON
4 Not used
Power failure report
5
0: OFF 1: ON
D346
Do not change these settings.
COMMENTS
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
60 SM