Ricoh D009 Service Manual page 916

Bit Switches
I-fax Switch 01 [SP No. 1-102-002]
FUNCTION
No
Original Line Resolution of TX
Attachment File
0 200x100 Standard
1 200x200 Detail
2 200x400 Fine
3 300 x 300 Reserve
4 400 x 400 Super Fine
5 600 x 600 Reserve
6 Reserve
mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail.
There is no switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to
7
determine the setting, mail cannot negotiate between terminals; the mm/inch
selection is determined by the sender fax.
When this switch is Off (0):
Images scanned in inches are sent in inches.
Images scanned in mm are sent in mm.
Images received in inches are transmitted in inches.
Images received in mm are transmitted in mm.
D346
this size before sending. The default is A4.
If the width selected with this switch is higher than
the receiving machine can accept, the machine
detects this and this causes an error.
COMMENTS
These settings set the maximum resolution of the
original that the destination can receive.
0: Not selected
1: Selected
If more than one of these three bits is set to "1",
the higher resolution has priority. For example, if
both Bit 0 and Bit 2 are set to "1" then the
resolution is set for "Bit 2 200 x 400.
70 SM