Ricoh D009 Service Manual page 910

Bit Switches
No FUNCTION
TTI printing position
0: Superimposed on the page
0 data
1: Printed before the data
leading edge
2 Not used
TTI printing type
3 0: Address unit
1: File unit
4-6 Not used
7 Not used
System Switch 12 [SP No. 1-101-019]
No FUNCTION
TTI printing position in the
0-7
main scan direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No FUNCTION
D346
COMMENTS
Change this bit to 1 if the TTI overprints
information that the customer considers to be
important (G3 transmissions).
Do not change the factory settings.
TTI printing unit can be selected.
Do not change the factory settings.
Japan Only
COMMENTS
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI from the left edge of the paper. If the TTI is
moved too far to the right, it may overwrite the file
number which is on the top right of the page. On
an A4 page, if the TTI is moved over by more than
50 mm, it may overwrite the page number.
COMMENTS
64 SM