Installation Procedure - Ricoh D009 Service Manual

items were sealed in the box at the factory before you do the installation.
1. Check the box seals [1] on each corner of the box.
Make sure that a tape is attached to each corner.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
install the components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the
box.
3. You can see the "VOID" marks [2] when you remove each seal. In this condition, they
cannot be attached to the box again.

1.22.3 INSTALLATION PROCEDURE

1. Remove the slot cover [1] (
2. Turn the SD-card label [2] to face the rear of the machine. Then push it slowly into slot 2
until you hear a click.
3. Turn on the main power switch, and then enter the SP mode.
4. Select SP5878-002, and then press "Execute" on the LCD.
5. Exit the SP mode after "Completed" is displayed on the LCD.
6. Turn off the main power switch.
7. Remove the SD card from slot 2.
8. Attach the slot cover [1] (
9. Login to User Tools as the Administrator.
10. Go to [User Tools] [System Settings] [Administration Tools] [Machine Data Encryption
Settings] [Encrypt]
SM
x 1).
x 1).
1-79
HDD Encryption Unit
D009/D011/D012/D013