Configuration Synchronization - Samsung WEC8500 Operation Manual

10.10 Configuration Synchronization

For all APCs in an environment configured with multiple APCs to provide the same
WLAN service, all their service-related settings, other than the individual network settings,
must be identical. For this, the system provides a function for automatically synchronizing
service-related configurations across multiple APCs.
When service settings are changed on the master APC, the settings are automatically
applied to the connected slave devices. Service configuration synchronization currently
supports two APCs only.
10.10.1 Configuration Information Synchronization
Configuration using CLI
[Adding APC to APC List]
Add APCs to synchronize to the APC list by referring to 'APC List Management'.
[Adding APC to Sync List]
After adding APCs to the APC list, APCs to synchronize must be added to the Sync List.
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
2) Add APCs to the Sync List.

add-apc[INDEX][APC_NAME][IPV4_ADDRESS]
Parameter
INDEX
APC_NAME
IPV4_ADDRESS
[Deleting APC from Sync List]
Registered APCs can be deleted from the Sync List.
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
© SAMSUNG Electronics Co., Ltd.
Description
INDEX on the Sync List (range: 1-2)
APC name (maximum 18 characters)
IPv4 address
CHAPTER 10. System Management
page 507 of 689