Figure 208. Configuration Window For Unauthorized Ap Detection Option - Samsung WEC8500 Operation Manual

Figure 208. Configuration Window for Unauthorized AP Detection Option

8.2.2.6 Unauthorized client detection option
Operator can enable or disable the client detection option pre-defined in the system.
Configuration using CLI
1) Go to configure  wi  device  client configuration mode.
WEC8500# configure terminal
WEC8500/configure# wi
WEC8500/configure/wi# rogue
WEC8500/configure/wi/device# client
WEC8500/configure/wi/device /client#
2) Configure the unauthorized client detection option by using the following command.

[OPTION] [NOTI_TYPE]
Parameter
OPTION
NOTI_TYPE
The description of OPTION parameter is as follows:
Parameter
assoc-fail-det
© SAMSUNG Electronics Co., Ltd.
Description
Rogue Client detect option
Event save option
- notify: Notify the state with alarm
- detect: Save the state with sys log
Description
Classifies a client that exceeds the association fail threshold
as an unauthorized client.
CHAPTER 8. Security
page 396 of 689