Samsung WEC8500 Operation Manual page 184
Wireless enterprise access point controller
Hide thumbs
Also See for WEC8500:
- Operation manual (680 pages) ,
- Maintenance manual (88 pages) ,
- Operation manual (534 pages)
Table of Contents
Advertisement
Parameter
LED-CONFIG
OVERWRITE-VLAN
VLAN-SUPPORT
NATIVE-VLANID
OVERWRITE-POE-TYPE
POE-TYPE
OVERWRITE-UPLINK-
BANDWIDTH
UPLINK-QOS
OVERWRITE-
TEMPERATURE-ALARM
TEMPERATURE-ALARM-ON-
LEVEL
TEMPERATURE-ALARM-
OFF-LEVEL
TEMPERATURE-ALARM-
CONTROL-TYPE
OVERWRITE-LINK-
AGGREGATION
LINK-AGGREGATION
OVERWRITE-LINK-TEST
LINK-TEST
5) Use the 'show ap-group detail [AP_GROUP_NAME]' command to check the AP
group information.
© SAMSUNG Electronics Co., Ltd.
This configures whether to turn the LED on/off.
If overwrite-vlan is enabled, the VLAN settings of the AP group
are applied to all APs within the group.
This configures whether to enable the native VLAN of the AP.
This configures the native VLAN value of the AP.
If the overwrite-poe-type is activated, the POE Type information
set in the AP group is applied to all APs in the group.
Sets the POE Type information below.
802.3at/802.3af/auto
If the overwrite-uplink-bandwidth is activated, the uplink
bandwidth information set in the AP group is applied to all APs in
the group.
Sets the allowed value for AP uplink Qos.
Can configure 0~63 as DSCP method.
If the overwrite-temperature-alarm is activated, the temperature
alarm information set in the AP group is applied to all APs in the
group.
If the temperature of the AP exceeds the Temperature-Alarm-On-
Level, the temperature alarm occurs.
The default is 98 and possible to set between 50 and 130.
If the temperature of the AP is less than the Temperature-Alarm-
Off-Level, the temperature alarm is cleared.
The default is 90 and possible to set between 50 and 130.
If the temperature alarm occurs, whether the radio of the AP is
set to be off or on.
If the overwrite-link-aggregation is activated, the link aggregation
information set in the AP group is applied to all APs in the group.
In case of an AP model for 802.11ac, provide two uplink Ethernet
ports.
Possible to set link aggregation for two Ethernet ports.
If link aggregation is activated, possible to set the following
mode:
- Both (Destination + Source)
- Destination
- Source
In case of enabling overwrite-link-test, link-test information which is
assigned AP group is adopted to all AP in the group.
Check quality of WAN when AP making a booting.
CHAPTER 4. AP Connection Management
Description
page 184 of 689
Advertisement
Table of Contents
