Figure 258. Remote Ap Group-Alc Profile Configuration - Samsung WEC8500 Operation Manual

Configuration Synchronization (Remote AP Group)
The W-EP WLAN system provides a function of synchronizing the configuration of the AP
of the remote group and ACL if the AP of the remote group operates as a local bridge.
8.7.4.3 Requesting Synchronization
If the remote AP operates with the local switching mode, the configuration of the ACL
between APC and AP must be synchronized. If AP and CAPWAP run, the configuration of
the ACL is automatically synchronized, but if the operator changes the ACL of the APC,
the synchronization of ACL configuration must be performed as follows:
Configuration using CLI
The synchronization of the AP of the remote group uses the following CLI:
WEC8500# configure terminal
WEC8500/configure# rbac
WEC8500/configure/rbac# sync-config ?
acl-profile
all
ap
remote-ap-group

all: Perform synchronization for all APs of the remote group.

remote-ap-group [group-name]: Performs synchronization only for the APs included in
the corresponding remote group.
© SAMSUNG Electronics Co., Ltd.

Figure 258. Remote Ap Group-Alc Profile Configuration

Sync-config Acl profile
Sync-config All
Sync-config Remote Ap Group
Sync-config Remote Ap Group
CHAPTER 8. Security
page 450 of 689