Operator can perform detail configuration only when you enter a summary-address.
The detail configuration includes advertise or TAG configuration.
1) Advertise Configuration
The default is set to Enable. Therefore, if no-advertise is selected in the CLI, the
configuration is changed to Disable.
2) Tag
A tag is a user-defined 32-bit tag value between 0 and 4294967295. A tag also has a
default value and it is 0.
WEC8500/configure/router/ospf 2# summary-address 11.1.1.1/16
WEC8500/configure/router/ospf 2# summary-address 11.1.1.1/16 tag ?
0 - 4294967295
WEC8500/configure/router/ospf 2# summary-address 11.1.1.1/16 tag 3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Network> <OSPF> <Summary> menu in the sub-menus.
The configuration page is as follows:
After default configuration, select a PROCESS ID for detail configuration.
The detail configuration includes advertise and TAG configuration mentioned in the CLI.
Unlike CLI, there is no no-advertise. A user can change the default Enable to Disable.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
32-bit tag value
page 112 of 689