Managing Real-Time Information Collection - Samsung WEC8500 Operation Manual

Stopping information collection
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) 'Disable' the traffic performance information management.
WEC8500/configure# no stats-report enable
3) To check the configured information, use the 'show stats-report conf' command.

10.5.2 Managing Real-time Information Collection

1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) To collect real-time information, execute the following command. At this time, you
must specify the name and status of an interface whose information will be collected.

stats-report current-stats [INTERFACE_NAME] [STATE]
Parameter
INTERFACE_NAME
STATE
3) To check the entered information, use the 'show stats-report conf' command.
4) To check the information of a configured interface when the real-time information
collection is configured, execute the following command.

show stats-report current-stats [INTERFACE_NAME]
If the real-time information collection is suspended or initialized, you cannot check the
real-time information of the interface.
WEC8500/configure# show stats-report current-stats ge3
Error: This interface was not configured to gather statistics.
© SAMSUNG Electronics Co., Ltd.
Description
Name of an interface to collect or stop collection
Status of real-time information (start/stop)
- start: Starts real-time information collection
- stop: Stops or initializes the real-time information collection.
CHAPTER 10. System Management
page 491 of 689