Samsung WEC8500 Operation Manual page 51


: Show the current setup step and the whole setup step by being located on the top of
the screen. When you hover the mouse over each number, it shows the name of the
step and you can click to move to the step just before or after the current step.

: When you press the Next button, you move to the next setup step and when you
press the Prev button, you return to the previous setup step.

: Press the Exit button to close the wizard and then move to the general WEC screen.
In the case, you cannot return back to the initial setup wizard screen. If the APC
restarts while the WLAN is not created, you can go to the wizard screen again.
Setup Step
The initial setup wizard consists of the following setup steps: After setting up the
description desired on each screen, click the Apply button to apply the modifications to the
system.
1) General setup:

Set up basic information including the name, location, contact number, etc. of the
system.

Set up the basic country code and the basic environment.

Set up the system time and the time zone. Click the PC TIME button to change the
time of the APC by setting to the time of the PC.
2) Interfaces:

Create interfaces. For more information, refer to '3.2.1 Interface Management' and
'3.3.1 VLAN'.
3) Interface groups:

Create interface groups and assign the interfaces created at the previous step.
For more information, refer to '3.2.2 Managing Interface Group'

4) Default Gateway:

Set up a default gateway of the system. The default gateway is a default path to be
used when the APC communicates with another equipment on the TCP/IP network.
5) WLAN:
Create a WLAN. For more information, refer to '5. WLAN Management'.


If the L2 Security Type corresponds to one of the following conditions, move to the
step of setting up a RADIUS server. For more information on creating a RADIUS
server, refer to '8.1.1 External RADIUS Server'.
(1) 802.1x
(2) Static WEP + 802.1x
(3) +WPA2 and enabled 802.1x
6) DHCP proxy:

When an external DHCP server is used, configure settings of proxy or relay.
7) DHCP internal server:
Configure a DHCP internal server. For more information, refer to '5.4.1 DHCP

Server'.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 2. Basic System Configuration
page 51 of 689