Figure 135. Local Switching Configuration Window Of Wlan - Samsung WEC8500 Operation Manual

WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1# profile
WEC8500/configure/ap ap_1/profile#

local-bridging [WLAN_ID][VLAN_ID/ACL_NAME/PRE_AUTH_ACL_NAME]
Parameter
WLAN_ID
VLAN_ID
ACL_NAME
PRE_AUTH_ACL_NAME
4) Operator can check the configuration information by executing the 'show remote-ap-
group summary', 'show wlan detail', 'show ap local-bridging [AP_PROFILE_
NAME]' command.
Configuration using Web UI
By referring to the 'Configuring Remote AP Group', add an AP to a remote AP group.
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. Select a WLAN ID to change in the WLANs screen
and go to the <General> tab. After changing the 'CAPWAP TUNNEL MODE' to 'Local
Bridging', click the <Apply> button.
© SAMSUNG Electronics Co., Ltd.
WLAN ID (Range: 1-254)
(available only for WLANs the tunnel-mode of which is local-bridging)
VLAN ID (Range: 1-4094)
ACL name to configure for the WLAN service
(only for options set in IP ACL)
ACL name to configure for pre-authentication of the WLAN
(only for options set in IP ACL)

Figure 135. Local Switching Configuration Window of WLAN

CHAPTER 5. WLAN Management
Description
page 245 of 689