7.10.2 Detecting WLAN-based Communication Failure
You can configure whether to detect WLAN-based communication failure.
Configuration using CLI
1) Go to the configure mode of the CLI.
APC# configure terminal
APC/configure#
2) Enable or disable communication failure detection.
[no] call-fail-detect [WLAN_ID]
Parameter
WLAN_ID
3) To check the configured connection limitation information, use the 'show voip config
[WLAN_ID]' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <CONFIGURATION> and then select
the <WLANS> menu in the sub-menus. Select a WLAN ID to change in the WLANs
screen and go to the <Advanced> tab.
After configuring the VOIP FAILURE DETECT item, click the <Apply> button.
© SAMSUNG Electronics Co., Ltd.
Figure 190. Detecting WLAN-based communication failure
CHAPTER 7. WLAN Additional Services
Description
WLAN ID (range: 1-240)
page 349 of 689