4.2.4.3
AP Mode Configuration
Configuration using CLI
To configure AP mode, execute the command as follows.
1) Go to configure AP configuration AP profile mode of CLI.
WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1# profile
WEC8500/configure/ap ap_1/profile#
2) Configure the AP mode.
ap-mode [MODE]
Parameter
MODE
3) To check the information of a configured AP, use the 'show ap detail [AP_NAME]'
command.
© SAMSUNG Electronics Co., Ltd.
Figure 108. AP Profile Setting (2)
AP operation mode (generalAp/rootAp/repeaterAp/snifferAp/relayAP)
- generalAp: Typical operation mode. Default value.
- rootAp: AP mode where a repeater AP can be connected.
- repeasterAp: AP mode that is connected to a wireless area and the APC
through the root AP.
- snifferAp: AP mode where the packets operating in a wireless
environment can be captured.
- meshAp: AP mode of wireless connection between APC and root AP or
another mesh AP.
CHAPTER 4. AP Connection Management
Description
page 208 of 689