Samsung WEC8500 Operation Manual page 187

Configuring SSL (Smart Service Link) of AP Group with CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.
ap-group[AP_GROUP_NAME]
3) Enter the profile configuration mode for the AP group.
profile
4) Configure the SSL function for the AP group.

enable: Enables/disables the SSL function.

target-ap: This option is used for selecting APs that will have the changes applied to
the group settings. If 'all' is selected, changes are applied to all APs and the config
priority of the APs also change to group. If 'keep-ap-config' is selected, only the APs
whose config priority is set to group have the SSL value of the group applied to
them.
WEC8500# configure terminal
WEC8500/configure# ap-group default
GroupName : default
WEC8500/configure/ap-group default# sta-ssl
WEC8500/configure/ap-group default/sta-ssl# ?
decision-delta
enable
number-of-channel
one time scanning
number-of-proreq
during one time scanning
scan-time-channel
scan-time-interleave Set interval time required for new scanning
start
scan-time-service
STA's scanning
scan-trigger-level
target-ap
<cr>
WEC8500/configure/ap-group default/sta-ssl# enable ?
<cr>
WEC8500/configure/ap-group default/sta-ssl# decision-delta ?
1 - 100
WEC8500/configure/ap-group default/sta-ssl# number-of-channel ?
1 - 20
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
Set delta value for handover decision
sta-ssl enable
Set the number of channel required during
Set the number of probe request required
Set time required for one channel scanning
Set time required for STA service during
Set a trigger level for STA's scanning start
Set config target ap
Enter the value [dBm]
Enter the number
page 187 of 689