Wlan-Based Acl Configuration - Samsung WEC8500 Operation Manual

Parameter
CAPABILITIES
12) Configure whether to permit TDSL for WLAN of Local bridging mode. Default is
disable.

[no] tdls-blocking
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. For more information about configuration, see '5.1
Basic WLAN Configuration'.
5.1.3

WLAN-based ACL Configuration

To configure ACL to apply to the WLAN service, define IP-based ACL first and then
configure it to the WLAN.
Configuration using CLI
The procedures for configuration are as follows.
1) Before applying ACL, retrieve ACL that is configured as WLAN ACL.
WEC8500# show running-config network
fqm-mode
...
ip access-group wireless acl1
!
2) Go to configure  wlan configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
© SAMSUNG Electronics Co., Ltd.
- link-measurement
- neighbor-report
- beacon-passive-measurement
- beacon-active-measurement
- beacon-table-measurement
- statistics-measurement
- ap-channel-report
CHAPTER 5. WLAN Management
Description
page 236 of 689