External Byod Server - Samsung WEC8500 Operation Manual

Wireless enterprise access point controller

Hide thumbs Also See for WEC8500:

Table of Contents

External BYOD Server

The W-EP WLAN system provides a function of interoperating with the external BYOD

server. To use the BYOD function, a separate BYOD server is necessary. Employees and

guest users can receive a service after being connected to a specific WLAN (SSID) and

going through authentication.

(The external BYOD server now supported is only AirCuve BYOD.)

Configuring External BYOD Server

Configuration using CLI

To configure the interoperation with external BYOD, execute the command as follows:

1) Go to configure  security  byod of CLI.

WEC8500# configure terminal

WEC8500/configure# security byod

2) Enter the IP address of the BYOD server.

WEC8500/configure/security/byod# address1 10.10.10.20

To interoperate with AirCuve BYOD Suite, enter Airfront IP in address1 and Byfront

IP in address2.

3) Enable the function of interoperating with the external BYOD server.

WEC8500/configure/security/byod# enable

4) Configure a HTTPS request URL.

Upon the interoperation with AirCuve BYOD Suite, the HTTPS request URL is

necessary to update the list of all authentications. The basically set value is used and if

change is required in the future, change as follows:

WEC8500/configure/security/byod# https-requrl

regist.do?cmd=dhcpTableXMLReceiver

5) To check the configured environment, use the 'show security byod configuration'

CHAPTER 8. Security

page 453 of 689