Configuration using CLI
To configure the Range detail items, start detail configuration after entering an Area range
prefix value.
WEC8500/configure/router/ospf 2# area 2 range ?
A.B.C.D/M
WEC8500/configure/router/ospf 2# area 2 range 10.10.10.1/16 ?
advertise
not-advertise
<cr>
WEC8500/configure/router/ospf 2# area 2 range 10.10.10.1/16
The detail items include advertise or no-advertise configuration
Configure whether to advertise to the range or not.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Network> <OSPF> <Area> <Range> menu in the sub-menus.
The configuration page is as follows:
5) Detail configuration
Configuration using CLI
This is additional explanations for Area. Operator can configure authentication, default-cost,
or shortcut.
WEC8500/configure/router/ospf 2# area 2 ?
authentication
default-cost
or stub area
filter-list
nssa
range
(border routers only)
shortcut
stub
virtual-link
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
Area range prefix
Advertise this range (default)
DoNotAdvertise this range
Enable authentication
Set the summary-default cost of a NSSA
Filter networks between OSPF areas
Specify a NSSA area
Summarize routes matching address/mask
Configure the area's shortcutting mode
Configure OSPF area as stub
Define a virtual link and its parameters
page 109 of 689