Class-Map Configuration - Samsung WEC8500 Operation Manual

The initial window of Access Group is shown below. After selecting a configuration, click
the <Apply> button to configure Admin ACL.
3.5.2

Class-map Configuration

1) Go to the fqm mode to configure the configure  ACL rule of CLI.
APC# configure terminal
APC/configure# fqm-mode
2) Go to Class-map mode.

class-map c1
3) Select match-all or match-any.

match-type [MODE]
Parameter
MODE
4) Perform detail configuration according to match criteria.
Match Criteria
access-group
class
COS
destination IP range
IP
protocol
source IP range
5) Exit the Class-map mode.

exit
6) To check the configuration information, use the 'show running-config network'
command.
© SAMSUNG Electronics Co., Ltd.
Figure 55. Admin ACL Configuration Window
Match mode configuration (match-all/match-any)
match access-group [ACCESS_GROUP_NAME]
match class [CLASS_NAME]
match cos [COS_VALUE/any]
match dst ip range [A.B.C.D] [A.B.C.D]
match ip dscp [DSCP_VALUE/any]
match ip precedence [IP_PRECEDENCE_VALUE/any]
match ip tos [TOS_VALUE/any]
match protocol [PROTOCOL_VALE/any]
match src ip range [A.B.C.D] [A.B.C.D]
CHAPTER 3. Data Network Function
Description
Description
page 129 of 689