Samsung WEC8500 Operation Manual page 528

2) enable-alert: Configure whether an alert occurs regarding Channel-Utilization, Air-
Quality, and Noise-Level.
ex.) air-quality alert
../network-stats/alert/rf-value/enable-alert# air-quality enable
../network-stats/alert/rf-value/enable-alert# no air-quality enable
3) threshold: Configure the alert threshold of each RF value by radio.
ex.) air-quality 5G threshold  90
../network-stats/alert/rf-value/threshold/80211a# air-quality 90
4) count-alert: An error count threshold to generate an alert in RF Statistics
If the error count is greater than the threshold by statistical period due to the RF values
exceeding the threshold,
an alert occurs. If the value is 0, the alert of the corresponding period does not occur.
ex.) error count threshold per day  720
../network-stats/alert/rf-value/count-alert# day1-threshold 720
5) Retrieve the status of configuration of the RF statistics.
WEC8500# show network-stats statistics rf-value summary
6) Retrieve the RF statistics of the RF values by AP.
ex.) Statistics of air-quality of AP 43
WEC8500# show network-stats statistics rf-value air-quality 43
© SAMSUNG Electronics Co., Ltd.
CHAPTER 10. System Management
page 528 of 689