Setting Ap Group Parameter - Samsung WEC8500 Operation Manual

6) To calibrate the RSSI value depending on types of stations, the calibration value must
be set.

calibration mobile [NUMBER]

calibration pc [NUMBER]

calibration others [NUMBER]
Parameter
NUMBER
7) To exclude stations where the traffic occurs from load balancing, the following option
must be set (Default: no idle-station):

idle-station
8) The following option must be configured to use the HandOver function of Smart
Service Link. (default: no ssl-ho)

ssl-ho

7.15.2 Setting AP Group Parameter

Station-based Adaptive Load Balancing must set operating parameters to the radio of the
corresponding AP group because it operates in a radio unit of the AP group.
Configuration using CLI
To set AP group parameters, execute the command as follows:
1) Go to the load-balancing configuration mode in configure  AP Group of CLI.
APC# configure terminal
APC/configure# ap-group lb
APC/configure/ap-group lb# load-balancing
APC/configure/ap-group lb/load-balancing#
2) Go to the radio to perform the Station-based Adaptive Load Balancing function.
APC/configure/ap-group lb/load-balancing# radio 1
APC/configure/ap-group lb/load-balancing/radio 1#
3) Activate load balancing in the corresponding radio.

enable
4) Set the interval to attempt at the Load Balancing function.

interval [NUMBER]
© SAMSUNG Electronics Co., Ltd.
RSSI calibration value (-dbm)
- Default value: 0 dbm
CHAPTER 7. WLAN Additional Services
Description
page 372 of 689