Figure 6. Optic Port Configuration - Samsung WEC8500 Operation Manual

When connecting a cable to the management port, make sure to check if the cable complies
with the 10 BASE-T, 100 BASE-TX, or 1000 BASE-T.

Cable type: UTP or STP cable using RJ-45 connector
 10 BASE-T: Category 3 or higher
 100 BASE-TX: Category 5 or higher
 1000 BASE-T: Category 5 or higher (Category 5e or higher is recommended)

Isolate from wireless frequency disturbing waves

Shut down electrical surge

Separate the electrical wiring of a switch or related devices and the electromagnetic
area of network data line

Cable or connector and safe connection without damaged cable sheath
The 1000 BASE-T standard does not support the forced mode.
The auto-negotiation function must be always used for 1000 BASE-T port or trunk
connection.
Optic port
It provides two 10 GbE Optic ports and eight 1 GbE Optic ports and the operational status
of each port is displayed in LED.
1G port
LINK/ACT LED
Configuration item
10 GE ports
1 GE port
© SAMSUNG Electronics Co., Ltd.
CHAPTER 1. Access Point Controller System Overview
1G port
Connector

Figure 6. Optic port configuration

Port/LED
LINK/ACT 1, LINK/ACT 2
10G 1, 10G 2
LINK/ACT 1~LINK/ACT 8
1G 1~1G 8
10G port
LINK/ACT LED
Description
LINK/ACT status of each port
- Turned on for link connection
- Blinking for data exchange
10 GbE Optic module connector
LINK/ACT status of each port
- Turned on for link connection
- Blinking for data exchange
1 GbE Optic module connector
10G port
Connector
page 29 of 689