Interface Configuration - Samsung WEC8500 Operation Manual

3.2

Interface Configuration

The WEC8500 interface consists of the following physical interface and virtual interface.

Physical interface of 11 ports except console port

1024 virtual interfaces using VLAN
There are two types of WEC8050 interface as shown below; physical interface and virtual
interface.

Physical interface of 4 ports except console port

128 virtual interfaces using VLAN
3.2.1 Interface management
The WEC8500 Management port is used to manage the WEC8500. It does not
support VLAN and its interface name is 'mgmt0'. The 8 ports at the right side of
Management port are 10/100/1000 BASE T-ports and their names are GE1-8.
To the right side of the 10/100/1000 BASE T-ports, there are two Gigabit ports, i.e.
XE1 and XE2.
Configuration using CLI
To configure the interface related function, go to the interface mode by entering the
'interface [INTERFACE_NAME]' command in the configure mode. An example of
entering into the interface mode of the management port is shown below.
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
WEC8500/configure/interface mgmt0#
The interface related CLI commands are as follows:
[ip address]
This is a command that configures a static IP address. The 'no' parameter is used to delete
the configuration.

ip address {A.B.C.D/mask length}

no ip address {A.B.C.D} {A.B.C.D}

no ip address {A.B.C.D/mask length}
[ip address dhcp]
This is a command that configures a dynamic IP address using DHCP. The 'no' parameter
is used to delete the configuration.

ip address dhcp

no ip address dhcp
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
page 65 of 689