Figure 110. Ap Cli Account Add/Remove Window - Samsung WEC8500 Operation Manual

3) An account can be deleted by entering the 'no' parameter as shown below.

no ap-account [ID]
4) Use the 'show apc ap-account' command to retrieve the AP configuration information.
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, and then select
<Local Management Users>  AP in the submenu.
Click the 'Add' or 'Delete' button to add or delete the AP CLI account.
4.2.4.5 AP SNMP Agent Configuration
The APC operator can configure SNMP Agent settings for all APs.
Configuration using CLI
Execute the following commands to configure the SNMP Agent settings of the AP.
1) Go to configure  snmp  ap mode of CLI.
WEC8500# configure terminal
WEC8500/configure# snmp
WEC8500/configure/snmp# ap
WEC8500/configure/snmp/ap#
2) Configure the snap agent information of the AP.
Enable/disable SNMP of the AP.

enable or no enable
Configure the SNMP port number of the AP.

Port [PORT NUMBER]
Configure the Read Only Community Name of the AP.

ro-community [COMMUNITY NAME]
Configure the Write Only Community Name of the AP.

rw-community [COMMUNITY NAME]
© SAMSUNG Electronics Co., Ltd.

Figure 110. AP CLI Account Add/Remove Window

CHAPTER 4. AP Connection Management
page 210 of 689