Samsung WEC8500 Operation Manual page 185

Configuring AirMove Service of AP Group with CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.

ap-group [AP_GROUP_NAME]
3) Enter the profile configuration mode for the AP group.

profile
4) Configure the AirMove service of the AP group.

enable: Enables/disables the AirMove service.

target-ap: This option is used for selecting APs which will be applied with the
changes made to the group settings. If 'all' is selected, changes are applied to all APs
and config priority of the APs also change to group. If 'keep-ap-config' is selected,
only the APs whose config priority is set to group have the airmove value of the
group applied to them.
WEC8500# configure terminal
WEC8500/configure# ap-group default
GroupName : default
WEC8500/configure/ap-group default# airmove
WEC8500/configure/ap-group default/airmove# ?
decision-delta
enable
exit
number-of-channel
one time scanning
number-of-proreq
during one time scanning
scan-time-channel
scan-time-interleave
start
scan-time-service
STA's scanning
scan-trigger-level
start
target-ap
<cr>
WEC8500/configure/ap-group default/airmove# enable ?
<cr>
WEC8500/configure/ap-group default/airmove# decision-delta ?
1 - 100
WEC8500/configure/ap-group default/airmove# number-of-channel ?
1 - 20
WEC8500/configure/ap-group default/airmove# number-of-proreq ?
1 - 10
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
Set delta value for handover decision
Airmove enable
Exit from airmove mode
Set the number of channel required during
Set the number of probe request required
Set time required for one channel scanning
Set interval time required for new scanning
Set time required for STA service during
Set a trigger level for STA's scanning
Set config target ap
Enter the value [dBm]
Enter the number
Enter the number
page 185 of 689