Samsung WEC8500 Operation Manual page 110

Authentication configuration
Operator can select whether to use authentication or message-digest function.
WEC8500/configure/router/ospf 2# area 2 authentication ?
message-digest
<cr>
WEC8500/configure/router/ospf 2# area 2 authentication message-
digest ?
<cr>
WEC8500/configure/router/ospf 2# area 2 authentication message-digest
Default-cost configuration
Configure a value between 0 and 1677215 as a default-cost. However, operator can
configure the default-cost value in AREA ID whether a stub or NSSA is configured.
If you try to configure the default-cost in an ID where neither the two items are configured,
the following error phrase is displayed.
'% The area is neither stub, nor NSSA'
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost ?
0 - 16777215
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3 ?
<cr>
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3
Shortcut configuration
For Shortcut configuration, operator can select one out of 3 selections including default,
disable, and enable.
WEC8500/configure/router/ospf 2# area 0.0.0.1 shortcut ?
default
disable
enable
WEC8500/configure/router/ospf 2# area 0.0.0.1 shortcut enable
WEC8500/configure/router/ospf 2#
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Network>  <OSPF>  <Area>  <Detail> menu in the sub-menus.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 3. Data Network Function
Use message-digest authentication
Stub's advertised default summary cost
Set default shortcutting behavior
Disable shortcutting through the area
Enable shortcutting through the area
page 110 of 689