10.4.3 External Transmission Configuration
All the alarms and events in the system are transmitted to outside through the SNMP trap
and syslog. If the alarm filter information is configured, only filtered alarm is transmitted to
an external management server.
10.4.4 Alarm Filter and Level Configuration
An alarm filter can be configured per group or level (severity). The filtered alarms are
transmitted to an external server through the SNMP trap and syslog.
Configuration using CLI
The procedure of alarm filter configuration is as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Configure group information.
WEC8500/configure# alarm group system
3) Configure level information.
WEC8500/configure# alarm level major
4) To check the configured alarm filter information, use the 'show alarm conf' command.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 10. System Management
page 488 of 689