Figure 235. Nat Configuration (1) - Samsung WEC8500 Operation Manual

[DNAT Configuration using Static IP]
To add DNAT using a static IP, execute the command as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Configure a NAT to the interface.
WEC8500/configure# interface vlan1.30
WEC8500/configure/interface vlan1.30#ip nat outside
WEC8500/configure/interface vlan1.30#exit
3) Configure a NAT rule using a static IP (A port can be also specified for DNAT).
WEC8500/configure# ip nat outside destination static tcp 10.10.10.1
4300 30.30.30.2 23
[Checking NAT Configuration]
To check the created NAT, use the following command.
WEC8500/configure# show nat
Configuration using Web UI
1) In the menu bar of <WEC Main window>, select <Configuration> and then select
the <Security>  <NAT>  <Pool> menu in the sub-menus. Click the <Add>
button and configure the NAT pool.
© SAMSUNG Electronics Co., Ltd.

Figure 235. NAT configuration (1)

CHAPTER 8. Security
page 429 of 689