Dcs Configuration - Samsung WEC8500 Operation Manual

7.4.3

DCS Configuration

This section describes the setting options of the DCS function which automatically sets the
channel of the AP.
Configuration using CLI
1) Go to configure  rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Go to the wireless section where you want to change the settings.
WEC8500/configure/rrm# 80211a
3) Set the DCS function. Enter the dcs setting mode and set it to 'enable'. Use the 'no'
parameter to disable the mode. The function operates only when the RRM is set to
Enable.
WEC8500/configure/rrm/80211a# dcs
WEC8500/configure/rrm/80211a/dcs# enable
4) Configure whether to apply the DCS-DPC joint algorithm. If the 'no' parameter is
selected, the configuration is cleared.
WEC8500/configure/rrm/80211a/dcs# joint-algo-enable
5) Execute the following command to change the execution interval. The default value is
120 (seconds).
WEC8500/configure/rrm/80211a/dcs# periodic-interval [value]
6) Execute the following command to change the Channel Utilization threshold.
The default value is 80 (%).
WEC8500/configure/rrm/80211a/dcs# channel-utilization-threshold [value]
7) Execute the following command to change the My Utilization threshold.
The default is 10 (%) for 802.11a and 40 (%) for 802.11b.
WEC8500/configure/rrm/80211a/dcs# my-utilization-threshold [value]
© SAMSUNG Electronics Co., Ltd.
CHAPTER 7. WLAN Additional Services
page 321 of 689