Syslog Configuration - Samsung WEC8500 Operation Manual

10.7 Syslog Configuration

The system log (syslog) configuration is required to transmit an event, alarm, and system
log information to a target syslog server. You can configure maximum two target syslog
servers in the system and you can configure the IP address and port number independently.
In addition, because you can configure a filter level, only filtered log information is
transmitted to the syslog server.
Configuration using CLI
To transmit an alarm, event, and system log to the syslog server, executes the command as
follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) To transmit an alarm, event, and system log information to the syslog server, specify
'enable' as a parameter.
WEC8500/configure# syslog enable
3) Configure the IP address and UDP port of a target syslog server (The default of the
UDP port is '514'.).
WEC8500/configure# syslog add 192.168.0.91
WEC8500/configure# syslog add 192.168.0.99 udpport 510
4) Configure a log level to filter.
WEC8500/configure# syslog level information
5) To check the configured syslog information, use the 'show syslog conf' command.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 10. System Management
page 498 of 689