Configuring Web Authentication On Mac Authentication Failure - Samsung WEC8500 Operation Manual

8.3.4 Configuring Web Authentication on MAC Authentication
Failure
To provide the service of Web Authentication on MAC Authentication Failure, the MAC
Authentication of security L2 of the WLAN must be enabled and the web policy of L3 and
the web authentication of the captive portal must be configured.
Configuration using CLI
[WLAN Configuration]
To configure Web Authentication on MAC Authentication Failure in the WLAN, execute
the command as follows:
1) Go to configure  WLAN configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
2) Go to configure  WLAN  security  layer 3 configuration mode of CLI.
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# layer3
WEC8500/configure/wlan 1/security/layer3#
3) Enable the WEB authentication (default: disabled).

web-policy macAuthFailure
WEC8500/configure/wlan 1/security/layer3# web-policy macAuthFailure
4) Next step, refer to CLI of 8.3.2 Web Authentification.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 8. Security
page 416 of 689