Samsung WEC8500 Operation Manual page 204


edge-ap: Configures whether to enable the Edge AP function.

edge-ap-opmode: Smart Handover is enabled as operation mode of the edge AP.
In RSSI mode, handover is determined by looking up the RSSI value. In Force
mode, handover is performed by force.

edge-ap-threshold: Configures a threshold value for performing smart handover at
the edge AP (range: -60 to -100 dBm, default: -80 dBm).

edge-ap-window: Configures a window value for performing smart handover at the
edge AP (range: 200-1000 ms, default: 200 ms).

fragment-size [SIZE]: Configures a fragment size based on MTU to prevent the
fragmentation of a CAPWAP packet that is transmitted by an AP to the APC.

ip-mode [dhcp/static/ap]: Configures the IP address of an AP to DHCP, Static or AP
Followed.

dhcp: Configures the AP IP operation type to DHCP

static: Configures the AP IP operation type to static

ap: Operates with an IP configured in an AP

led-config: Configures LED on/off setting of the AP.

on: Sets LED of the AP on.

off: Sets LED of the AP off.

off-time: Sets LED of the AP off only for specific hours.

local-bridging: Configures WLAN-VLAN Mapping of the Local Switching WLAN,
ACL, and Pre-Authentication ACL of Captive Portal for each remote AP.

vlan-id: Configures a VLAN ID to allocate to the Local Switching WLAN.

acl-name: Configures an ACL name to allocate to the Local Switching WLAN for
packet allowance/blocking.

pre-auth-name: Configures a Pre-Authentication ACL name for Captive Portal
operation of the Local Switching WLAN.

location [STRING]: Configures the information of location where an AP is installed.

mac [MAC_ADDRESS]: Configures the MAC address of an AP

max-echo-retransmit [COUNT]: Configures the maximum number of
retransmission times of an echo request message.

max-retransmit [COUNT]: Configures the maximum number of retransmission
times of a CAPWAP control message.

name [STRING]: Configures an AP name.

native-vlanId [VLAN_ID]: Configures the native VLAN in an AP.

primary-apc [APC_AME]: Configures the name of a primary APC.

secondary-apc [APC_AME]: Configures the name of a secondary APC.

tertiary-apc [APC_AME]: Configures the name of a tertiary APC. The WEC8050
model does not support the tertiary-apc function.

repeater-whitelist [MAC ADDRESS]: Adds the Repeater AP Whitelist.

report-interval [INTERVAL]: Configures the time interval for an AP to transmit the
description error to the APC (Unit: seconds)

retransmit-interval [INTERVAL]: Configures the waiting time until the AP
retransmits a CAPWAP control message when there is no reply from the APC (unit:
seconds)
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
page 204 of 689