Samsung WEC8500 Operation Manual page 199

4.2.2.7 Configure Interface of Remote AP Group
If you want to assign multiple VLAN ID to WLAN which is belong to Remote AP Group
and configured as a Local Bridging, assign Interface and Interface group and assign
Interface group to an assigned WLAN.
You can add max. 16 VLAN ID for each Remote AP Group, and can create max. 16
Interface Group. And you can assign VLAN ID to a created Interface Group.
Configuration using CLI
To configure Remote AP Group Interface, Excutes following command.
1) Excute configure  Remote AP Group Interface configure mode using CLI.
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote interface
2) Add or delete VLAN

vlan [VLAN ID]

no vlan [VLAN ID]
3) Can check VLAN information using 'show ap-group remote interface vlan [REMOTE
AP GROUP NAME]'command.
4) Add or delete Interface Group.

if-group [INTERFACE GROUP NAME]

no if-group [INTERFACE GROUP NAME]
5) Can check VLAN information using 'show ap-group remote interface if-group
[REMOTE AP GROUP NAME]'command.
6) Assign or delete VLAN in a Interface Group.

add-if [VLAN ID]

no add-if [VLAN ID]
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<AP Groups> menu in the sub-menus.
After selecting the name of the remote AP group, you can configure DHCP in the
"INTERFACE" item of the 'Remote AP Group' tab.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. AP Connection Management
page 199 of 689