Ip Multicast Routing Configuration - Samsung WEC8500 Operation Manual

Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Network>  <Static Route> menu in the sub-menus.
The configured static route list is displayed on the window. When you click the <Add> or
<Delete> button, you can add or delete a static routing entry.
After adding or deleting an entry, check if the information is reflected to the list in the
Static Route window. If the added information is not displayed, it means the added routing
information is not enabled. If the operational status of an interface that will be used as a
routing result is not UP, check the interface status through CLI or Web UI.
Because only enabled routing entries are listed in the Web UI, you cannot remove a
disabled routing entry.
3.4.3

IP Multicast Routing Configuration

1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Enable or disable multicast-routing.

ip multicast-routing

no multicast-routing
3) Check multicast-routing using the 'show running-config network' command.
© SAMSUNG Electronics Co., Ltd.
Figure 45. Static Routing Configuration Window
CHAPTER 3. Data Network Function
page 80 of 689