Samsung WEC8500 Operation Manual page 530

Wireless enterprise access point controller

Hide thumbs Also See for WEC8500:

Table of Contents

Configuration using CLI

1) Check the configuration of the data traffic statistics and if the status is set to be

disabled, set to be enabled.

WEC8500# show network-stats statistics data current-config

WEC8500/configure/network-stats/statistics/data# enable

2) To retrieve the statistical information of a specific AP, enter as follows:

WEC8500# show network-stats statistics data ap-stat 1

3) To retrieve the statistical information of RTP of a specific AP, give a RTP option as

WEC8500# show network-stats statistics data ap-stat 1 rtp

4) To retrieve the statistical information of all APs, enter as follows:

WEC8500# show network-stats statistics data apc-stat

5) To retrieve the statistical information of RTP of all APs, give a RTP option as follows:

WEC8500# show network-stats statistics data apc-stat rtp

6) To generate a packet loss alert from the AP, enter as follows:

WEC8500/configure/network-stats/alert/data# packet-loss-alert enable

7) To generate a packet retry alert from the AP, enter as follows:

WEC8500/configure/network-stats/alert/data# packet-retry-alert enable

Configuration using Web UI

In the menu bar of <WEC Main window>, select <Configuration> and then select <

Statistics>  <Network Quality>  <APs>  <802.11a/n/ac>  <Data Traffic> in the

CHAPTER 10. System Management

page 530 of 689