Figure 220. List Window For Blocking Ap - Samsung WEC8500 Operation Manual

8.2.4.1 Configuring Manual Blocking
To configure manual blocking, execute the command as follows:
Configuration using CLI
1) Go to configure  wids  containment configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wids
WEC8500/configure/wids# containment
WEC8500/configure/wids/containment#
2) Configure manual blocking.

manual [TARGET] enable [MAC]
Parameter
TARGET
MAC
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Monitor> and then select <Wireless
Intrusion> menu in the sub-menus.
Select the target and perform containment to perform manual blocking.
1) After selecting an AP in the AP list, possible to block by using the containment.
© SAMSUNG Electronics Co., Ltd.
Select either AP or station which is the target for manual blocking.
MAC address of the target for manual blocking

Figure 220. List Window for Blocking AP

CHAPTER 8. Security
Description
page 406 of 689