SATO CL4NX Operator's Manual page 235

Cable Specifications
Cable Connector
Cable Length
Notes
• When using READY/BUSY control, make sure that the printer is in power on mode before you send the data
from the host.
• With the communication protocol such as XON/XOFF, STATUS3, STATUS4 or STATUS5, receive buffer full
error will occur when the received data is more than the receive buffer size (2.95 MB). Send the data that is
less than 2.95 MB while monitoring the status of the printer.
• The parity error will be detected if this error occurs after the reception of ESC+A.
DB-9 Male or equivalent
15 m (50 feet) or less
7 Appendix
CL4NX Operator Manual
233